The d:dicate 4007C Stereo Pair with Clips and Windscreens in Peli Case Kit from DPA includes two 4007 omnidirectional capsules, two MMP-C compact preamplifiers, two microphone clips, two foam windscreens, and a Peli case for safe transportation and easy access to the microphones and accessories. It can be used to capture audio for drums, percussion, and brass instruments, in recording and rehearsal applications, and more.
Description
he wide and versatile d:dicate™ Microphone series is legendary in the high-end recording and film production industry. Delivering clean, accurate sound, the mics in this series are used by professionals, who understand sound and insist on only using the best.
4007 Omnidirectional Stereo Pair, 12 mm
Even though the standard tolerances on our d:dicate™ microphones are extremely low, a stereo match is even closer. These specially selected d:dicate™ 4006 Microphones are matched within ±0.5 dB on both frequency response and sensitivity. The pair comes in a heavy-duty Peli™ Case for safe transportation and easy access to the microphones and accessories.
The d:dicate™ 4007 Omnidirectional Microphone, 12 mm
The 4007 Omnidirectional Microphone, 12 mm is a true pressure omnidirectional transducer. It has an unbeatable dynamic range of 124 dB from the noise floor to 1% THD. It is capable of handling up to 160 dB SPL peak before clipping occurs.
Due to its total acoustical transparency and ultra-high SPL handling capability, the 4007 Omnidirectional Microphone, 12 mm has gained a reputation as being the first choice for picking up drums, percussion and brass instruments, whenever a natural and non-distorted result is paramount for recording applications.
ST4007C Stereo Pair
When a small, lightweight, inconspicuous microphone for top-quality recordings or measurements is required, the compact design and clean, transparent sound of this versatile mic is the perfect choice.
Tech Specs
Directional pattern: Omnidirectional
Principle of operation: Pressure
Cartridge type: Pre-polarized condenser
Frequency range: 10 Hz - 40 kHz
Frequency range, ±2 dB: 20 Hz - 40 kHz
Sensitivity, nominal, ±2 dB at 250 Hz: 9 mV/Pa; -41 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 24 dB(A) re. 20 µPa (max. 26 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 36 dB (max. 38 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 70 dB(A)
Total harmonic distortion (THD): < 0.5% up to 142 dB SPL peak
Dynamic range: Typ. 124 dB
Max. SPL, peak before clipping: 152 dB
Minimum load impedance: 2 kΩ
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common mode rejection ratio (CMRR): > 50 dB
Power supply (for full performance): 48 V Phantom power (±- 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Microphone diameter: 12 - 19 mm (0.47 - 0.75 in)
Capsule diameter: 12 mm (0.47 in)
Microphone length: 64 mm (2.5 in)
Maximum output voltage, RMS: 4.5 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40°C to 45°C (-40°F to 113°F)
Relative humidity (RH): Up to 90%
Matching tolerance (frequency response and sensitivity): ±0.5 dB
Phase deviation for kit: < 5°
Contents
- 2 x 4007 Omnidirectional Capsules
- 2 x MMP-C Compact Preamplifiers
- 2 x Microphone Clips
- 2 x Foam Windscreens
- Peli Case
